Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Case intrusion sensor
#1
Hi,

is it possible to implement a feature to read the status of the case (chassis) intrusion sensor???
Reply
#2
Yes, it is Smile But it has never been considered an important feature and nobody asked for this yet Wink
Reply
#3
Hi Martin,

can you please implement that feature? Smile
Reply
#4
Yep, what sensor chip do you have (displayed in the sensors window) ?
Reply
#5
Nuvoton NCT6771F

Thanks Big Grin
Reply
#6
I have just released build 1315 which implements this feature for the most common sensors.
Please let me know how it works.
Reply
#7
Thank you very much, ill try it and let you know
Reply
#8
Just a question, when is open it says "Chassis Intrusion --- Yes", so i suppose that when it doesnt appear the "Chassis Intrusion" entry is when is closed right?

Thanks a lot Martin Smile
Reply
#9
Right, but I'll update it to show "No" if no intrusion is detected too.
Reply
#10
Thank you again Martin Smile
Reply
#11
Hi Martin,
thanks for this new feature.

We are now having an issue with sensor ITE IT8721F, we are always having "Chassis intrusion --- Yes" even when we are sure that there is not. Also, we are having a bad reading of the voltages.

Best regards

--
Vallel


Attached Files
.jpg   sensores_H67H2-I (ECS).jpg (Size: 170.38 KB / Downloads: 198)
Reply
#12
The case intrusion sensor detection might be a 'sticky' information - it's reported as "open" until you reset that information. Does it report intrusion immediately after reboot?
As for the voltage readings, this mainboard needs specific adjustment. Please send me a HWiNFO32/64 Report File, Debug File including sensor data and a photo of the BIOS system health screen. Then I can fix it.
Reply
#13
We have reseted the status of the chassis and we are still having "Chassis intrusion --- Yes".

We are checking on the bios and there is no info about +5v, +3v, +12v :|, do you think is possible to fix this? or is this the reason to get innacurate voltages info?

This is a new BIOS (graphical) that we havent seen before.

--
Vallel


Attached Files
.rar   report.rar (Size: 92.17 KB / Downloads: 7)
Reply
#14
I have verified the data I receive from chip and according to documentation there's really "Chassis intrusion" being reported.
I'll fix the voltage and temperature values (in next build) to be reported the same way as BIOS. AVCC3 is the +3.3V rail from which the sensor is powered, however +5V and +12V rails don't seem to be monitored on this mainboard (the BIOS doesn't report them too).
Reply
#15
Ok, thank you Martin
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)