Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Fan detection and control for Sager NP9870 (Clevo P870DM-G)
I'd like to use HWiNFO to control this notebook's fans if possible. This machine has SLI 980M's and three fans. The built in software seems to only read the CPU temperature and left on "automatic" the fans run too slowly, and not until the GPUs are already up into the 60C+ area.


.dbg   HWiNFO64.DBG (Size: 3.32 MB / Downloads: 5)

.htm   NOSHPC.HTM (Size: 168.88 KB / Downloads: 2)
Shame. I was hoping I'd find a utility that could at least read the fan speeds.
Fan speed reading might be possible, as this is a Clevo model and some are supported.
For that I'd need you to provide an Embedded Controller dump using the RW-Everything tool:
See this thread for more information:

Forum Jump:

Users browsing this thread: 1 Guest(s)