Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
HWINFO x64 not initially showing on Logitech G15
#1
Greetings.  I hope this post finds you well.  I could not find a post that suggested this issue, nor one that was in the time frame of the release I am using.  I am running HWINFO64 5.22.2280 and Logitech x64 8.82.151 drivers for my G15 (older version) keyboard.  This is also running on Windows 10 x64 Professional.  Prior to this release (both versions have been updated recently), I was able to press the toggle button on the keybaord to cycle through displays.  Now, initially, the display will not show HWINFO, although it is checked ON in the Logitech software.  In order to get it to show, I need to open HWINFO Sensors-Configure Sensors-Logitech LCD, select an option which is selected as YES to display, uncheck Show Value On LCD, then check it again.  I can now cycle through to show HWINFO on the display.  Thoughts?  Feelings?
Reply
#2
Do you remember what was the previous HWiNFO version you used ? If yes, can you try it to see whether it will work as before ?
Reply
#3
(04-04-2016, 09:32 PM)Martin Wrote: Do you remember what was the previous HWiNFO version you used ? If yes, can you try it to see whether it will work as before ?

It was the last full version, 5.20.2800, and I still have the installer.  I can try it, but I know that downgrading Logitech software tends to be a nightmare.

Have you any thoughts about this issue before I start the battle?
Reply
#4
Sorry, I have no thoughts. I haven't changed anything in the LG LCD code for long time, so I don't think the problem is caused by the HWiNFO upgrade, but I wanted to be sure.
Reply
#5
Same in 5.20.2800, so it must be Logitech. Doubtful they are going to do anything about it.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)