Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Win 7 & Win 10 Crash
#1
Hi all

I use the HWiNFO to monitor burn-in test status, then system sometimes crashes as soon in 5 minutes.
After system crashes, 80 port shows 5D. 

Anyone know it? or have the same experince?

Thanks in advance.
Reply
#2
Without further system details it's not possible to give an advice.
Please attach the HWiNFO Debug File of the crash for analysis.
Reply
#3
(10-17-2017, 08:20 AM)Martin Wrote: Without further system details it's not possible to give an advice.
Please attach the HWiNFO Debug File of the crash for analysis.

Hi Martin

Thanks for the reply. The file upload to Google Drive.
Please see the following link : DBG File
Reply
#4
This seems to be some conflict when polling the internal GPU. Are you perhaps running some other monitoring tools in parallel? If yes, try to close them and see if that solves it.
If not, try to enable the "Prefer AMD ADL" option in main HWiNFO settings.
Reply
#5
(10-17-2017, 09:48 AM)Martin Wrote: This seems to be some conflict when polling the internal GPU. Are you perhaps running some other monitoring tools in parallel? If yes, try to close them and see if that solves it.
If not, try to enable the "Prefer AMD ADL" option in main HWiNFO settings.

Hi Martin

Thanks for the reply. 
I will try it later, and response results in here.

I have another question, will HWiNFO cause the system loading to increase?
Reply
#6
(10-17-2017, 10:16 AM)Y3N3Y Wrote: I have another question, will HWiNFO cause the system loading to increase?

Like any other active application or monitoring tool, each readout from sensors can cost some CPU time. But usually this should be minimal, though some sensors can cause higher load, see here for more details: https://www.hwinfo.com/forum/Thread-IMPO...own-Issues
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)