Recent content by fileani

I usually know where to put the ram and I have no idea, why I did what I did. But at least at some point I got the idea to look inside the PC. PRD is still between 110-113%. No change there.

I was my fault, I solved the problem. My RAM was not in the Dual Channels. I put them into A1 and B1 instead of A2 and B2. Putting them in the right channels let me enable DOCP succesfully. Here are my new HWInfo readings. I hope it's okay now. And thank you so much for your help! You gave me...

I enabled DOCP and set it to DDR4-3200 but the moment I saved the settings my system had an instability. I attach before and after pics and the save mode message after I hit save, also HWInfo and 3DMark score. I am quite puzzled that the after pic stills shows only 2400MHz Frequenzy at the side...

You're asking me good questions that I don't really have an answer to because I'm not familiar with BIOS. But I will go and have a look. So I assume XPM/DOCP should be set to auto or on in Bios? Or should I write/specify the 1600MHz somewhere in BIOS? And PBO on or off? Sorry for asking such...

Because of my new PC I watched my temps etc. in hwinfo and that's when I noticed that my power reporting deviation was not in the normal range. So I ran Cinebench on the side and my PRD is always between 110-113% under full load. How can I get the RRD into the normal range between 90-110 %? I...