Hey Martin.
I'm not too sure what you mean by 0 and zero. I'll post some debug files:
a.One where CAM is off and the program is monitoring fine. http://puu.sh/zWJic/9d7f219d4d.png
b.One where it works, then i turn CAM on then it stops monitoring. http://puu.sh/zWJx6/6906c95e5d.png
c.And one...
I have a kraken x61 and the values are always 0.
However, if i turn off CAM software, HWINFO64 will then start to properly monitor values.
It seems that CAM has some sort of exclusive access to the x61.
Is there a way to work around this?
Thanks in advance. ...