Search results

  1. O

    Fan Control

    Ok Martin. I'll try it. Best regards, oZ
  2. O

    Fan Control

    yep, it stops.. when the power adaptor is reconnected, the fan starts again. All Windows Policies are setted to "active" cooling (fan spinning)
  3. O

    Fan Control

    Only stops when the computer runs on battery. The charge leasts for 1.5-2hour run..
  4. O

    Fan Control

    Yep.... When the AC power chord is unplugged, fan stops. It only spins by Manual Fan speed and Set Speed commands
  5. O

    Fan Control

    I've modified. When the temperature reaches any level, PWM stays at minimum value... could be changed only manually.
  6. O

    Fan Control

    Application runs (autostart), I detect that fan is not running, open Sensor Status, look at SMSC EM2113, detect that Fan1 is not present (line clear, no RPM..). Click on botton icon (which opens Fan Control), enable manual mode, change the Manual Fan speed slider from 0 (it returns to zero...)...
  7. O

    Fan Control

    Precisely... OpenFanCtrlMin option is enabled, fan only runs if I manually open the Fan Control. [hr] Should I try to flash an older BIOS version and use a legacy HWiNFO? I've found a 3.7 (seemed different than that used before format..) ... no fan at all... Could you point me to 3.9 or early...
  8. O

    Fan Control

    Unfortunately does not start... it only starts when AC power is on... Is there a way (gadget, HWiNFO64.ini...) to call/enable FAN? (like click in icon, manual mode and adjust speed)
  9. O

    Fan Control

    I've used this option to start HWiNFO, is there a option to force fan..?. HWiNFO starts but FAN not. In fact, OpenFanCtrlMin=1, was disabled because HWiNFO freezed on autostart with debug enabled. Should I enable UEFI at BIOS?:rolleyes:
  10. O

    Fan Control

    I this snapshot, I've clicket at FAN icon and set manual mode to start fan. Battery powers the computer. Thanks in advance oZ [hr] I've formatted the computer and install W7 and HWiNFO, everything worked before this ocasion. I don't remember what HWiNFO version I was using, probably...
  11. O

    Fan Control

    ok! Updated to latest, 4.36 Debug snapshot taken using AC power chord, battery charging. I'll take another running on battery. Thanks in advance, oGrOZion [hr] Howdy, here comes HWiNFO64-battery, depicting battery powered computer. Note that FAN is not appearing in SensorStatus. FAN...
  12. O

    Fan Control

    Dear Martin, The fan1 is not showed in sensor list at HWiNFO Sensor Status when running on battery. To enable it I have to click on FAN icon. Running HWiNFO64 v4.30 on HP Elitebook 2540p with SMSC EMC2113. Thanks in advance, oGrOZion
Back
Top