Search results

If you think about that the newer(than z390) platform vrms have so much headroom that actually run outside of their optimal efficiency z690 master is capable of 19*105A z790 master is capable of 20*105A only for IA cores and you draw 1/10th of it

I think 7.64 is the first official release that has the enhanced support for the vrm. As for the losses, they should be accurate enough.

Keep in mind that this not only happening after the pc is suspended/resumed, it also happens after 2 or 3h of uptime after a normal power cycle.

Hey martin, I have noticed that after some hours(or if you put the pc into sleep and then resume) that the hwinfo is running it gets cold, what I mean by that, it is still running but it doesn't refresh the sensors and being extremely laggy. Tried also the latest one(5215), issue persists Here...

Tbh, I haven't researched yet what else(if so) the controller can report neither which are the other controllers(vccaux etc) and what they support but I assume because they are low current, ITE's readings should be accurate enough. Attached should be the first boot log. Tbh, I didn't noticed...

This should be it

Bullseye!!!! Works :cool::cool::cool: Is there any more info that we can squeeze out of the renesas controller? .\attached a debug if you want it,.

my apologies here is a new one

Hm, I did that. Did I upload you the log before the reboot?

unfortunately same thing, no access to vr

I run it 3 consecutive times with their respective logs

Unfortunately still no data without the service and gcc app. The aftertools debug is after running the service and the gcc app that hwinfo has access to the vr.

Cool. In case you might need any other logs/troubleshooting, just let me know

So, After messing around a bit, apparently in order for hwinfo to grant access to the vr, the Gigabyte EasyTuneEngineService AND the Gigabyte Control Center app must have already been started/running. @Martin Is there any chance for hwinfo to have access to the vr without the need of those...

I see. If you want me to try something/troubleshoot or anything let me know. Or it is what it is? *Just an info, this is the second 790 master board that I have had my hands on and I don't see vrm info.

here you go. *Sorry, I had to zip the .dbg file as it was 4mb and it exceed the attach limit.

Oh I see. In case there is still interest, I can provide you any logs/troubleshoot you might need. I have an z790 aorus master v1.0 with 13900k.

Hello, Sorry to bring back to life such an old thread but, did you ever had the chance to check if it is actually possible to get a vrout reading from z790 aorus master?