msi

  1. R

    Worrying Power Reporting Deviation

    At idle, my power reporting deviation fluctuates between around 70% to 105%. I ran Prime95 small FFTs (a consistent, 100% load) and the deviation fluctuated between 125% and 130%. After a few minutes, I stopped the test and the deviation spiked to 154% before returning back to typical idle...
  2. D

    Vdroop on MPG Z490 gaming carbon motherboard?

    Hi, first build and first time overclocker. I saw a couple of place that says to look for the Vdroop as its the voltage to look for when on load. I was searching on the sensor page on HwInfo64 and i saw a voltage (other than the vcore) whos been fluctuating while on load but its called VIN3 (no...
  3. T

    MSI Z490 Unify voltage sensors

    Could care less about VIN3 & VIN..... VIN5-6 has peaked my interest. The circled V values on cold pc startup sit around .95 and drop to .70v gradually overtime. Doing some troubleshooting and wanted to cross this off my list. MSI bios has quite a few misc. voltage settings that don't give...
  4. S

    MSI Z490 Unify, NUC126 V2/T2 showing and doesn't seem to relate to anything?

    Hi, I have a MSI Z490 Unify, and I'm having T2 and V2 showing up,V2 seems to fade out as if its not active then usually under load appear at 0.01v at the same time T2 switches to 125c and then when the V2 sensor seems to drop off T2 switches back to 25c, guessing its nothing to worry about, I...
Back
Top