z490

Hi, first build and first time overclocker. I saw a couple of place that says to look for the Vdroop as its the voltage to look for when on load. I was searching on the sensor page on HwInfo64 and i saw a voltage (other than the vcore) whos been fluctuating while on load but its called VIN3 (no...

Hi, I have 3 questions: 1. There is no VID voltage on in my HWINFO. Is this normal for that board? 2.Can I see whats entering from the VRM to the CPU, like VROUT on Gigabyte motherboards? Or ASUS have their own sensor for that? 3.The WHEA was showing me 0 errors, now I dont see it. How that...

Could care less about VIN3 & VIN..... VIN5-6 has peaked my interest. The circled V values on cold pc startup sit around .95 and drop to .70v gradually overtime. Doing some troubleshooting and wanted to cross this off my list. MSI bios has quite a few misc. voltage settings that don't give...

Hi, Sorry for the repost, i am yet to receive any reply on this topic though. I am an owner of a Z490 unify and i was wondering if die sense implementation on hwinfo is possible. There is also other boards that have the same controller and lack the die sense readings on hwinfo such as the z490i...

Hi, I have a MSI Z490 Unify, and I'm having T2 and V2 showing up,V2 seems to fade out as if its not active then usually under load appear at 0.01v at the same time T2 switches to 125c and then when the V2 sensor seems to drop off T2 switches back to 25c, guessing its nothing to worry about, I...