NCP81530 support in v8.02

[nodev]

Hi. After updating to v8.02 I noticed that my board (Asus TUF Z690) added support for VR VOUT via the OnSemi NCP81530. However, its showing much high VR VOUT than I expected (higher than before the droop). So, I just wanted to know how accurate are these readings? Also in the report, the sensors are not saving even though I'm opening the sensors window and then generating the report.

 

[Martin]

To include sensor data in report file, you need to enable the "Log all values for Report (consumes memory)" option in sensor settings.
But it would be much better if you could attach the HWiNFO Debug File with sensor data, that will tell me more.

 

[nodev]

I think the DBG file was too large and didn't get uploaded. Anyways, heres both.

 

[Martin]

I think the DBG file was too large and didn't get uploaded. Anyways, heres both.

Thanks. The VR VOUT should be correct. Can you try under full CPU load and compare how it matches with Vcore?

 

[nodev]

Under full load of OCCT small/extreme, the VCore is reporting 1.25-1.27 and VR VOUT is 1.45V.