No temp sensors?
- Thread starter technos
- Start date
Please enable Debug Mode in HWiNFO32, then run it, open the Sensors, close and send the HWiNFO32.DBG file too.
Also with the RW-Everything tool press the EC (Embedded Controller) button and attach that dump too.
I'll also check the QDRS DTS status..
Also with the RW-Everything tool press the EC (Embedded Controller) button and attach that dump too.
I'll also check the QDRS DTS status..
technos said:
Please try this build: <!-- w --><a class="postlink" href="http://www.hwinfo.com/beta/hw32_368_1136.zip">www.hwinfo.com/beta/hw32_368_1136.zip</a><!-- w -->
you should see a new Sensor which will contain your CPU temperature as most probably measured by an on-board sensor and monitoried via EC.
As for the DTS, this particular SKU (ES1 QDRS) has all thermal sensors disabled in CPU probably because of the early ES stage.
Please attach a new Report File using this build so I can check it too.
you should see a new Sensor which will contain your CPU temperature as most probably measured by an on-board sensor and monitoried via EC.
As for the DTS, this particular SKU (ES1 QDRS) has all thermal sensors disabled in CPU probably because of the early ES stage.
Please attach a new Report File using this build so I can check it too.
I think the TM1 reported as enabled by CPU is false, since according to my information all thermal sensors are disabled there (including TM1, TM2, THERMTRIP#, PROCHOT# and DTS). Be careful with this SKU since there is no mechanism that will shut down the CPU in case of a thermal runaway.
