Shared Memory Support crashes HWInfo64

DRegal

Member
After I patched to the newest version a few minutes ago, if I turn on Shared memory support, the whole program crashes.
 
Modbro but I've shut that down completely and stopped it's service and it still crashes immediately when I turn on sensors with shared memory turned on
 
Does the Debug File you attached capture the crash?
Did you enable Shared Memory first and then started sensors, or started sensors and then enabled Shared Memory?
 
Yes, I turned on debug, enabled shared memory and launched the program, started sensors... it crashed. I uploaded that Debug
 
Maybe a breakthrough on a possible bug. So I had just installed a new crucial T700 SSD but had not formatted it or given it a volume. The crash happened 100% of the time until I formatted and gave it volume. Only change at all that I know of and now it loads fine.
 
So just to make sure - this is the bug you reported initially (not a new one) and the Debug File you attached above is when the T700 didn't have a drive letter assigned?
Doesn't make sense to me because I can see in the DBG that it's assigned to P:
 
P: is something call Pcloud, its an online drive and was there prior to the T700 assignment. The T700 has drive letter F. The problem was this. Here is breakdown of chronology.
8.20 HWinfo installed and working
Shut down PC
Install Crucial T700
Boot PC
Load HWinfo64 Prompts for update to 8.22 which I do
Reload HWinfo, opens fine. Notice monitor for MODBros doesn't work.
Click Shared Memory Support On
Crash
Reload, no sensors Loads
Turn on Sensors, crash
Load and turn on Debug and repeat for log
Turn off HWinfo and finish setting up the drive with drive letter F:
Go back in to get you a new log and find it working
Only change between crash with sensors is assigning the drive letter F:
No reboots of system either, another thing I was about to try, but found it working.
 
Last edited:
Back
Top