Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Support of RTSS - Displaying HWiNFO32 sensor values in Games
#21
Thanks for the feedback.
500 ms might be too low for some systems, where certain sensors (like disk SMART or EC) can have larger delays in reporting values. You'll have to test this on yours, also check if this doesn't cause a higher system load.
Reply
#22
Very good. I like.
Reply
#23
Photo 
In HWNFO OSD sets the value Position 2, Position 4, order to it was through one blank line, but  RTSS FPS always without a blank line.

Is it possible RTSS FPS through the a blank line?

   
Reply
#24
As it turned out it is possible. Issue is closed.

   
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)