Ok, so the 5.07.2650 beta version seems to be working better. I restored my computer via an image backup that I had created prior to HWiNFO being installed (all of the crashing and subsequent hard powering down was causing my Windows install to get corrupted.)
Using the latest version I was...
Ok, so now I tried it with debug mode disabled (with the NAS powered on), and HWiNFO stopped at the same point (IDE\SCSI...). This time, when it crashed it froze the computer again (unlike the previous times with debug enabled, where it only crashed HWiNFO, but I was still able to use the...
As previously reported, the 7 files I sent were performed when:
Files labeled "-1-" - performed with WD NAS management software turned off
Files labeled "-2-" - performed when BOTH NAS software turned off AND the mapped network drive disconnected.
HWiNFO should not have had anything to...
Here are the results so far:
Files labeled "-1-" - I turned off the WD NAS management software
Files labeld "-2-" I disconnected the Mapped network drive
turning off the management software did not help, all 3 attempts failed to continue past the "Analyzing IDE\SCSI..."...
Disconnect it from the network or turn of the management software on my computer?
I'm not sure either would help as I have multiple computers connected to the same network running Windows 7 and Windows 10. All of them have the management software for the WD NAS installed an none of them are...
Thanks for the quick reply, on a Saturday. That kind of customer service is unparalleled.
I rebuilt the system and HWiNFO is no longer causing the system to crash, BUT it is still not working I have attached 3 debug files: Drive Scan enabled, Low level I/O and drive scan disabled. The...
I just did a complete rebuild of my system, and now HWiNFO isn't working.
Windows 10 - New Install
Asus Z97 Extreme6
Samsung SM951 (Boot Drive)
Western Digital Green 2tb (2nd drive)
Video - Onboard VGA
HWInfO Version: 5.04.2630, then 5.06.2640 (Both versions behave...