Recent content by Big Elf

I reinstalled version 4.36 and took a bit more time to go through and disable every item again. You were right earlier on, it was the SMART sensor readings. The ones for the SSDs had a minor effect but the ones for the mechanical hard drives were causing the bulk of the CPU utilisation.

Thanks for that. Quick update after opening up the 'Sensor Status' window and the 'Summary' Window (in version 3.80). It's when the Sensor Status window is open that the CPU utilisation increases, when it's minimised it doesn't seem to generate utilisation. I'll post the reports later when...

OK but it'll be a few days before I do it as I've spent a bit too much time already on this. At the moment I've reinstalled a disk image and gone back to version 3.80 and can't see any obvious means of creating the Report and Debug files? How do I do them?

I installed version 4.36 and went through every entry one by one and disabled monitoring and hid each item, noting CPU utilisation each time. The program was still showing 8% CPU utilisation in Task Manager with everything disabled and hidden. So even though it's not apparently monitoring...

I've been using HWiNFO64 for 3 or 4 years and find it very useful. I use it mainly to report my Swiftech 35X pump speeds and as a quick check on system temperatures. I also like the option of displaying the pumps speeds in the 'Notification Area'. I have noticed that with the later versions...