Recent content by learnfromit

I want to press Ctrl + P and to have this appear. (photo 1) And then when i press Ctrl + P to toggle it off, FPS from rtss remains. making me go to rtss and manually disable it as shown below in picture 2 ^this is all with hwinfo 64. With msi afterburner + rtss when i activate the overlay...

I was hoping to remove msi afterburner and only have HWINFO 64 + riva tuner running. But it appears that MSI afterburner is needed for FPS statistics. Is it possible for a fps counter to be added to HWinfo64 in the future? Because right now its possible to have cpu/gpu info + fps info control...

hi, good stuff. Is there anyway to add a toggle for RTSS fps? I have it set up so when I do my key bind, cpu/gpu info pops up. But as long as RTSS is running, even when i toggle off hwinfo64 info, RTSS still shows just the FPS in the corner. When i used to use MSI afterburner you could use that...

ok yep thats it, poll sleeping gpu wasnt working or it was just working on the integrated. ill leave this post up just incase someone else is stupid like me and forgets about optimus.

mk ill run a bench mark then try to set it during it.

reset my windows computer, am going through the steps of setting a custom fan curve again. have a 970m, successfully set the fan curve for cpu but gpu doesnt have a temperature source. The gpu temperature is still there in the sensor list and it also lets me set a manual fan speed. installed all...

well i feel stupid, dyslexia strikes again. that did it, thanks.

i stupidly updated my hwinfo64 and now fans wont activate on start up unless i open the fan tab in sensors. here are my settings. I also did the OpenFanCrtlMin=1 .ini edit. any ideas if what i jacked up? thanks. been tinkering for hours and the fans still wont spin on start up, proof of ini...