Excluding bus does #6 fixes it.
Sadly that disabled monitoring the vrm sensors.
Do you have any idea why I have to disable them?
I don't get it... when I was using Windows 7 I had no problem with hwinfo64, plus the sensor readings were loaded 10 times faster(which isn't a big problem, but...
Can you give me some more info on how to do that when editing through the .ini file.
I see the GPUI2CBusExclude=00000000 entry. Which value do I set? Just 6?
And when I try GPU I2C ADL I just put GPUI2CADL=1? While still having GPUI2C=1 also
Thanks for the info already.
I do hope to...
I managed to enable debugging by editing the .ini file.
Somehow when I then tried to open the program, sensors-only, it worked but took pretty long to load all sensors(30+ sec.)
So I closed it and tried it again. That gave me a brief BSOD followed by a black screen. Had to shut down by holding...
I can't do that...
The problem is the program crashes on startup. So I cannot even get into the settings.
System locks with either normal start, summary only or sensors only.
I can't.
When the sensors load the whole system crashes. Windows says to make a dump but also stays at 0% so I have to hard-reset the system.
Any indeas what to try?
Already re-installed hwinfo.
Hello,
Recently upgraded to Windows 8.1.
All works fine. Except hwinfo64.
Other monitoring software do work(hwmonitor, aida..)
I am kinda stuck here.
When I open hwinfo, while it loads the sensors I get a nice BSOD.
My system seems to te stable, made 10 runs of IBT-avx on very high...