Recent content by yuuta14

  1. Y

    Invalid values after hibernation

    So far, no issues encountered in 5 times hibernation-resume cycle! Could you pinpoint the problem and the solution based on these trials? Hopefully this will be included in the next stable release. I will give you an update if the issue shows up again.
  2. Y

    Invalid values after hibernation

    Unfortunately, in most cases the issue still persist 1 ISSUE 2 ISSUE 3 ISSUE 4 NO ISSUE 5 ISSUE
  3. Y

    Invalid values after hibernation

    Unfortunately the issue persists. Tried two times, reproducible. Tried it 5 times: Issue, Issue, No issue, No issue, Issue. It seems to happen randomly... Is there any chance that this is hardware problem?
  4. Y

    Invalid values after hibernation

    Just after I read your reply I hibernate my laptop and resume it right away, without activating debug mode. And yes, the value went erratic. After that I tried activating debug mode again, hibernate and resume. No erratic values.
  5. Y

    Invalid values after hibernation

    Hi Martin, hope this helps. Activated debug mode, hibernate for around 10 min, and resumed.
  6. Y

    Invalid values after hibernation

    Hi Martin, the issue still persists on the latest version (7.42-5030).
  7. Y

    Invalid values after hibernation

    I don't know what's happening but running HWINFO in Debug Mode, Hibernate, and Wake it Up DID NOT make the value erratic. I tried it 4 times. Running it in non-debug mode did.
  8. Y

    Invalid values after hibernation

    HWINFO shows invalid values on some parameters on Minimum and Maximum upon wake up from Hibernation. This behavior is reproducible. Device: G14 (2022) with AMD 6900HS and RX6800S.
Back
Top