Recent content by zoota

I found a workaround; in settings, I check both "show sensors on startup" and "minimize sensors on startup". Since the problem showed up only when the software is minimized to taskbar - this workaround works well, and keeps 'below certain value' triggers to execute as expected. Thought this...

No worries. I tried with an exe file instead of bat - still get the same results. Happens only when a trigger is set to 'below' value (opposite to 'above' value, which works fine).

Hi Martin, I've created a short video showing the CMD windows pop all together, right after opening Sensors GUI. The actual trigger was ~50 mins before that. https://www.screencast.com/t/CbqyubdN17pG LMKWYT!

Nope, they do reach it for sure. I disconnect the fans, so they should go to 0% and triggers the alert. Even after one hour, they won't trigger till I open the GUI of HWI, and you can see all of them trigger at once (several CMD windows open up at once). When I think about it now, it might have...

I see. I'm running a simple .bat file, which also runs smoothly on other sensor alerts. these are the settings: WDYT?

The Run a Program. Sometimes, only if I open the Sensors window, the alert will trigger

Hi, There are some alerts that only trigger when the software GUI is opened. In case the software is minimized to taskbar; it saves the trigger state, then only once I double-click the HWinfo icon, all alerts triggers at once. So far, this only happens for WATT (power) and FAN speed % sensor...

Thanks Martin

Hi, I've been searching for an answer in the forums, but no luck. What's the timeframe of the "maximum" value for sensors? (is it for as long as the software running, or something else?) Thank you!

Awesome! thanks so much.

Or did you mean change the "label" via "custom" tab in alerts?...

Cool, but how? I'm sending parameters from HWinfo's alert ("%s" "%v"), then it's being passed with the bath file, then through a Powershell script - the values have to be variables. Thanks!

Hi, I've set an alert for each of the GPUs on my system. The alert executes a batch file, with the two arguments "%s" "%v". Once triggered, I get the same name for all GPUs. Meaning, it says "GPU Memory Junction Temperature" for any card. I'd like to allow a unique name for each GPU instead...