Search results

I think you are right! This hwinfo.exe is actually part of the damn stream deck plugin! I wrongly assumed it was a daemon for this project. https://apps.elgato.com/plugins/com.exension.hwinfo https://github.com/shayne/hwinfo-streamdeck Very sorry for the confusion, I will raise it with them...

Agreed, but in all the cases at 8 minutes it is consistently rising. It doesn't allocate then sit; It eats 1mb every few seconds and is never freed. What is your test system's memory usage like? Would rerunning one of the tests longer be useful? Perhaps just the UI without starting in any mode...

Summary only mode, (40mb at 8 minutes, leak). Sensor only mode, I selected everything and hit Del (42mb at 8 minutes, leak). Still leakin' FWIW If the HwInfo UI is not run, the hwinfo.exe doesn't seem to leak, for the most part the process seems suspended and hovers around 8mb. If the HwInfo UI...

I have disabled the drive scan and reloaded. Its 40mb at 8 minutes, and growing. Will update again after some time. Its now at around 80mb at 17 minutes, sounds like a hard leak still. I'm not sure what else might be causing the issue. I have more than average amount of hardware, VR, streamer...

Its still leaking, 85mb+ already, I didn't restore the old settings. At a speed of roughly 270mb per hour.

I have now backed up my prefs, reset, enabled debug, reloaded (killed), run, and here is the output after it scanned (attached). I will later report back about the leak, though by the looks of it, its still leaking. [File removed]

I will do that. I can confirm with no sensors monitoring and a fresh hwinfo.exe, it has leaked 300mb in 3.5hrs or so. How much memory usage is expected normally?

I am an experiencing a consistent memory leak. hwinfo.exe will leak gigabytes of ram over a few hours, 1-5gb easy. CPU usage will also slowly increase till its heating up my CPU and my fans start roaring. Disabling all of the sensors doesn't seem to stop the leak, I will keep testing/isolating...