Anyone have an idea?

P

pondow

New Member
Hello there!

Just a quick question for anyone out there.

I have been using hwinfo64 on my first pc build. I love it but I have seen over the past several days when I wake my pc from sleep it shows vbat at 0.000v.

When I first installed it, it wasn't showing motherboard temp at all. Had to restart. Since then there has been no issues except with vbat after wake.

Any ideas would be greatly appreciated. Being my first build, i'm not sure if this is a known issue or if something is very wrong with my sensors...

Thanks in advance!
 
I don't think there's a problem, the complete Vbat reading might be bogus (and ignored) in many cases.
But this depends on the mainboard model you have and exact values you're getting.
 
You must log in or register to reply here.
Back
Top