The program ran fine for over at least 8 months in conjunction with my Aquasuite.
My Aquasuite was not displaying certain temps that I got from HWiNFO64 v6.14.
I updated my GPU driver (was planning on doing it anyway) and then uninstalled HWiNFO64 v6.14 and installed HWiNFO64 v6.20.
It should be noted that if I try to go back to v6.14 I stil have the same problems.
Immediately after install the program runs and goes to the "Run/Settings" window and the update window. Close update window.
Enter settings and reset preferences.
Check Auto Start and Debug Mode.
Disable Corsair Link and Asetek support. Click OK.
Click run in the "Run/Settings" window.
The Main Window and System Summary windows open. However, there is NO TASK running in the task bar (no icon). Task Manager does show it running.
Under Task Scheduler it was in a ready state that I had to force to run. Still there is NO TASK running in the task bar (no icon).
Now I select the "Sensors" button on the main window. The Spinning Circle of Waiting is running when mouse over program window. It will stay like this for an hour if you let it. Windows has to force the program to close.
I can reopen the program at this point to the "Run/Settings" window and the update window. Once again, the Main Window and System Summary windows open. I can access everything in the main window and the system summary window is active. However, as soon as I hit sensors, it stops working.
If I change the settings to have the sensor window display on startup, the main window opens but the system summary is greyed out and unpopulated. HWiNFO is non-responsive at this point.
There is no time where there is an actual TASK running in the task bar (no icon). Once I seen a greyed out box in the task bar, but not your regular icon.
I would appreciate any help with this. I really liked the program up to now, but I have been struggling with this for three days now and may need to look for a replacement. I need temp data for my Aquasuite.
My Aquasuite was not displaying certain temps that I got from HWiNFO64 v6.14.
I updated my GPU driver (was planning on doing it anyway) and then uninstalled HWiNFO64 v6.14 and installed HWiNFO64 v6.20.
It should be noted that if I try to go back to v6.14 I stil have the same problems.
Immediately after install the program runs and goes to the "Run/Settings" window and the update window. Close update window.
Enter settings and reset preferences.
Check Auto Start and Debug Mode.
Disable Corsair Link and Asetek support. Click OK.
Click run in the "Run/Settings" window.
The Main Window and System Summary windows open. However, there is NO TASK running in the task bar (no icon). Task Manager does show it running.
Under Task Scheduler it was in a ready state that I had to force to run. Still there is NO TASK running in the task bar (no icon).
Now I select the "Sensors" button on the main window. The Spinning Circle of Waiting is running when mouse over program window. It will stay like this for an hour if you let it. Windows has to force the program to close.
I can reopen the program at this point to the "Run/Settings" window and the update window. Once again, the Main Window and System Summary windows open. I can access everything in the main window and the system summary window is active. However, as soon as I hit sensors, it stops working.
If I change the settings to have the sensor window display on startup, the main window opens but the system summary is greyed out and unpopulated. HWiNFO is non-responsive at this point.
There is no time where there is an actual TASK running in the task bar (no icon). Once I seen a greyed out box in the task bar, but not your regular icon.
I would appreciate any help with this. I really liked the program up to now, but I have been struggling with this for three days now and may need to look for a replacement. I need temp data for my Aquasuite.