Recent content by ruggb

I have HWINFO V 8.24.5700.0 I have 4 sticks of memory. Row 0 & 1 are a pair and Row2 &3 are a slightly different pair When I look at memory I see this: Why is Row2 showing without "[P0 CHANNEL A/DIMM 1 ]"? Is it a HWINFO issue or an MSI MB/BIOS issue?

Yet it is properly labeling the module that is in the row? I would think the name of that row would be based on the row # not the module name or s/n? So why would it label it correctly for an identical module in Row: 3? Strange!

The first pair are Crucial and they show a serial number. Neither of the Corsair modules show a serial number but Row: 3 is OK, so why isn't Row: 2 correct? OR why isn't Row: 3 show the same as Row: 2? Why does the position of the module depend on reading a serial number - it is a physical slot...

I have four 8GB memory cards installed. Two pairs. Why does Row: 2 show different than the identical one in Row: 3? Shouldn't it be Row: 2 - [P0 CHANNEL A/DIMM 1] - 8 GB PC4-28700 DDR4 SDRAM Corsair CMK16GX4M2D3600C1B What happened to the [P0 CHANNEL A/DIMM 1] - Is it a HWINFO bug or something...

They were bought as a pair, so I assume the s/n are OK. But it may be an insertion issue. I'll have to check that. But I believe it worked ok under W10. Now I have W11. The memory is indicating 32GB, which is correct.

why is this showing one module different then the an identical one? row 2 & 3 are the same part number. What happened to [P0 CHANNEL A/DIMM 1]?

FYI This isn't a HWIFNO problem, but just in case someone else runs into it using HWINFO. I plug in an external usb drive and open HWInfo. When HWInfo opens it runs thru the scan and shows drives, but not the USB drive. I plug in an identical drive (mfg & model), same cable, same port and it...