HwInfo and NZXT CAM conflict

jrcbandit

New Member
HwInfo runs just fine when I don't have NZXT CAM running. I am using 7.64-5240 of hwinfo. Hwinfo will launch in sensor mode with CAM open, but when I click on CPU CCD1 to expand Core Temperature, HWinfo will freeze / become unresponsive and possibly crash. However, I can expand core temperature just fine when CAM is not running.

This is on a Asrock B650e Taichi lite motherboard with a 7800X3D processor, a NZXT Kraken X63 cooler running CAM 4.57.3
 
HwInfo runs just fine when I don't have NZXT CAM running. I am using 7.64-5240 of hwinfo. Hwinfo will launch in sensor mode with CAM open, but when I click on CPU CCD1 to expand Core Temperature, HWinfo will freeze / become unresponsive and possibly crash. However, I can expand core temperature just fine when CAM is not running.

This is on a Asrock B650e Taichi lite motherboard with a 7800X3D processor, a NZXT Kraken X63 cooler running CAM 4.57.3
I’m having the same issue. I thought it was a BIOS update, but switched back to the old one and no difference. I believe it’s an update from NZXT Cam. I started a support ticket with NZXT today. I came here to see if anyone else had this issue. Everything ran perfect together until recently.
 
Last edited:
Try to disable monitoring of the NZXT sensor in HWiNFO.
I did, didn’t help. I think it’s a Cam issue. If I start HWInfo after Cam starts, it won’t show anything from Cam like the NZXT AIO pump speed. If I start Cam after HWInfo, it shows the NZXT specs
 
Back
Top