Hwinfo Freez in calculation bus

[Kris85]

hwinfo during analysis, bus calculation, no response and I can't turn it off with any shortcuts or in the task manager, only reset the PC. Has anyone had a similar problem? I'd like to point out that I tried to disconnect the Xbox 360 controller, etc.

 

[Martin]

I'll need to see the HWiNFO Debug File to determine what's going on.

 

[Kris85]

I'll need to see the HWiNFO Debug File to determine what's going on.

I Understand how the program is supposed to create it since the program does not run and is freshly installed, unless I'm wrong, sorry I'm a noob in this matter
Right away say, it is neither in the main directory or in the username

I don't know if it's just this file

 

[Martin]

There's something weird going on with your USB devices, most likely the Razer Megalodon.
Trying to enumerate them returns several errors and then seems to hang.

 

[Kris85]

There's something weird going on with your USB devices, most likely the Razer Megalodon.
Trying to enumerate them returns several errors and then seems to hang.

I see :\
So it turns out that I have to remember to unplug the Megalodon every time, there have always been problems with these headphones

That's probably not it, I uninstalled the drivers etc and now it stops at ata earlier, hmm

 

[Martin]

The second debug data you attached indicates a hang during Namtai Wbuzz scan.
Perhaps the problem is rather in USB Host/Hub to which these devices are connected.

 

[Kris85]

The second debug data you attached indicates a hang during Namtai Wbuzz scan.
Perhaps the problem is rather in USB Host/Hub to which these devices are connected.

I see. Damn, if it weren't for the fact that when the program freezes, I have to reset my PC because all the shortcuts and task manager don't work and they don't close the program, I would play with unplugging and connecting each device if it was possible to force the program to close like that ;(

It's a pity because it's not an ordinary cheap hub, sadly
Well, if I knew what program I could use to open this file, debug + how to read it, I wouldn't bother and I would calmly disconnect and connect everything one by one.


Edit:
Strange thing, I disconnected the entire hub and connected it again, except that I turned off each device (hub with switches) and turned on each device + program one by one.
Almost all devices do not suspend the program, even Buzz, etc., until I connect Megalodon, then even if I disconnect it, other devices cause problems until I disconnect the hub and connect it, so it turns out what was said first. Megalodon causes havoc rrrrrrrr


Edit edit
It is served after
x when I run the program, it crashed again, this time on the sound card, strangely enough, when I disconnect the hub, the program starts, so I don't know, the hub mixes but only in this program it's sad