Network DL/UP rate shows and disappears

kuebk

New Member
Hello,

Since I started to use HWInNFOMonitor I've noticed that the DL/UP rates for my network card are not always shown, somethimes one of them or both disappers.

When this happens I have to go to sensor configurations, layout tab and click on restore original order - sometimes after 1st attempt sometimes after few attempts it shows DL/UP rates.

How can I fix this?

[attachment=900]
[attachment=901]

Thanks.
 

Attachments

Martin

HWiNFO Author
Staff member
Is this problem showing up only in HWiNFOMonitor, but in the HWiNFO sensors screen they are visible ?
Does this happen while having HWiNFO running, or only after starting HWiNFO ?
 

kuebk

New Member
It does happen while HWiNFO is running and I don't see them (both or just one of them) on the sensors screen unless I restore original order.
 

Martin

HWiNFO Author
Staff member
I found some potential issues there, will try to fix it in the next build released.
 
Top