Global polling rate + debug mode = settings GUI drawing problems.

Timur Born

Well-Known Member
Ahoi.

Thanks for the latest version (6.40). Small issue: when poll rate is under 200 ms and Debug mode is enabled then HWinfo struggles to draw its own GUI in the settings window. When I switch tabs it only managed to draw a single line and leaves the rest of the window blank.

Regards!
 

Martin

HWiNFO Author
Staff member
Thanks for the feedback regarding this change. I did quite significant changes to polling in the last version.
Debug Mode was not meant to be used in normal environment, so I don't consider this as a serious issue in case such a low polling rate is used. Try to disable the "Debug Write Direct" option, that should improve the performance in Debug Mode.
 

Timur Born

Well-Known Member
And thanks for this change indeed, it is well appreciated! :)

You are correct, disabling Write Direct solves this little problem and it is not significant. Just reporting FYI.
 
Top