MSI Z490 Unify, NUC126 V2/T2 showing and doesn't seem to relate to anything?

stead

New Member
Hi,

I have a MSI Z490 Unify, and I'm having T2 and V2 showing up,V2 seems to fade out as if its not active then usually under load appear at 0.01v at the same time T2 switches to 125c and then when the V2 sensor seems to drop off T2 switches back to 25c, guessing its nothing to worry about, I was curious more than anything.

v21.jpgv22.jpg


I was advised to post here based on this thread https://www.hwinfo.com/forum/threads/sensor-status-nuc126.6054/
 
Yes, both those values seem to be invalid and I will remove them in the next build to avoid confusion.
 
Back
Top