Hello, my HWINFO started showing an extra drive temperature on my SSD Samsung EVO 960 1TB. I did install a newer version of HWINFO so maybe thats why it showed up but I was just about this new sensor because it is showing the my NVME is at 68C while idle while the other 2 sensors are at 40C. When I ran burn in test the new sensor went up to 112 C, while the other 2 sensors were at 60 C (I turned my PC off after I saw 112 C dont worry) From what I could gather from Samsung, the EVO 960 only has 2 sensors on it, so im not sure where this information is being gathered from. Any insight would be appreciated, thanks.